Thursday, January 23, 2020

How to make a custom Male DC to Male DC Cable

In this post, I will show you how to make your own custom Male DC to Male
DC cable for DIY Projects without spending too much money.


You can also watch the video on how to make the cable

Things & Components you need

  • 2 * Male DC Jack
  • 1 * Wires (my wire is from an old charger)


First, remove the protective cover of the wire on the edges to expose the bare wire

Now remove the outer layer of the DC Jack & connect the wires to the jack.
In the Jack the longer pin will be GND & the shorter pin will be the VCC

Once the DC Jack connected to wires at both ends, enclose the jack with its outer
cover & do a connectivity test to test if anything is getting shorted.
If everything is fine then your good to go.

Pin Diagram

Thank you for reading !!!

No comments:

Post a Comment

Hi, Thanks for Commenting !!!